Seite 1 von 1

Multifunction with additional sounds V1.30d

Verfasst: Sa 27. Jun 2015, 15:27
von astecme
When assigning an additional sound to the Multifunction I get a warning saying that the sound is already in use. However it is not.
usm-RC-2.jpg
usm-RC-2.jpg (225.78 KiB) 4036 mal betrachtet
The attached picture shows the "error"

Re: Multifunction with additional sounds V1.30d

Verfasst: Sa 27. Jun 2015, 17:07
von Oldchap
Hello,

input sounds are not shown here. Is it sure that the sound is not used in accordance with an input?

Re: Multifunction with additional sounds V1.30d

Verfasst: Sa 27. Jun 2015, 17:44
von Rascal
I think oldchap is right, I get the same error if the sound is assigned to an input, if it's assigned to e.g. a Nautic switch or prop channel it will indicate that instead, so the error message gives a hint where to look (see tab "Inputs").

Re: Multifunction with additional sounds V1.30d

Verfasst: So 28. Jun 2015, 19:01
von astecme
Lol - not an input sound - an additional sound. and ths was never on an input selection previously.

Re: Multifunction with additional sounds V1.30d

Verfasst: Mo 29. Jun 2015, 08:01
von BEIER-Electronic Andy
Hello Allan,

can you please send me your project file?

Re: Multifunction with additional sounds V1.30d

Verfasst: Fr 10. Jul 2015, 16:16
von astecme
I would but it would not help - now that I have gone through the assignment- It does not do it the second time.