Seite 1 von 1

output sequence problem

Verfasst: Do 28. Mai 2015, 20:40
von bluepass
hey, after i installed the 1.30 update it not longer possible too use 2 or more output sequence at the same time?

Re: output sequence problem

Verfasst: Fr 29. Mai 2015, 07:43
von BEIER-Electronic Andy
Hello Arve,

yes, that is correct. In V1.30 is only one output sequence at the same time possible.

We must change this, because we want to enable the new 10 outputs of the EXM-2 also in sequences. But with so much outputs, the USM-RC-2 can't control 2 sequences at the same time.

But this has also an advantage: Now you can make up to 8 sequences, and every output can be in every sequence.

Maybe (dependent on the sequence type) you can make a third sequence which contains the outputs from the 1. and the 2. sequence?