Hello,
First I managed to get the squeeking sound to the tracks that I had on additional sound 3. However I had to remove the regular sound and add this squeeking sound to FG1 Normal in Engine sound tab section. Now it sounds great when going forward and reverse but I also would like to have some engine noise aswell and not just the squeeking sound. As you can hear the engine sound dissapeares when the excavator moves forward. How do I add some engine sound to the squeeking sound?
The engine sound consists of several "sub-"sounds - what you hear when there is no movement is the
idle sound (standgeraeusch.wav). Once the throttle is engaged the sound switches to
FG1 normal, which in your case is the squeeking sound (quitschen_01_kurz.wav).
Since
Engine sound 2 is used for rotation I see two options:
1. Remove the idle sound and put that sound file into a free soundslot under
Additional sound, then configure a
Multi function with "Engine sound on/off" and "Additional sound #". Replace the function "Engine sound on/off" under Prop #8 with "Multi function #".
2. Mix
quitschen_01_kurz.wav and
fahrgeraeusch.wav into a single sound file (e.g. by using Audacity) which then can be placed into the
FG1 normal slot.
Or consider this work-around:
- Put fahrgeraeusch.wav in soundslot FG1 normal
- Flatten the curve in the engine sound diagram along 100% (thus the sound will not change when throttle is engaged)
- Put quitschen_01_kurz.wav in soundslot Cornering squeak (will only be played when cornering but you can decrease the threshold to make it more sensitive under Configuration > Engine sound > Engine sound > Threshold cornering squeak)
- Instead of function "Additional sound 4" use function "Engine sound rpm change" (this should also solve the problem below)
However note that function "Engine sound rpm change" will currently have no effect since the value is set at 0% (
Configuration > Engine sound > Engine sound), so you should increase this.
Also, I have sound to each movement as you can see but regardless of what setting I use I can`t get it to be correct. The setting as you can see in the video is loop/immidiate stop and it works fine when doing each movement separately but when joining them together it starts and stops all the time as you can hear. Sounds terrible! How can I remedy this?
If you are not going to use the work-around above try adding
Additional sound 5 and 6, which you asked about before. Acually I am not sure this will work either since then the sounds will be started/played in parallel and may sound just as bad. But try it out please.
Else the only option I see is mixing channels (3 into 1) so that the sound will only be triggered by 1 channel, regardless how many movements happen simultaenously.
It seems like the sound for the tourret roation is gone now, why is that?
There is no trigger defined to switch
Engine sound 2 on. Tick the box "Turn on engine sound automatically by motion" under
Configuration > Engine sound > Engine sound 2. You can also set a delay for turning the sound off, though I guess 0 seconds would be fine since the sound should stop immediately when the rotation stops.