UFR1230 disconnecting from USM3
Re: UFR1230 disconnecting from USM3
The current draw on the larger actuators is less than 0.5amp and the smaller is 0.1amp
Re: UFR1230 disconnecting from USM3
One of the actuators causes the esc to beep once at the end of its travel. The others do not. May help diagnose
Re: UFR1230 disconnecting from USM3
Thanks, but one beep just means 'program restart'. Can't say from here what's the cause.
What happens if the actuator reaches its endpoint - are the any limit switches installed, or does the actuator somehow detect the end of travel by itself?
What happens if the actuator reaches its endpoint - are the any limit switches installed, or does the actuator somehow detect the end of travel by itself?
Re: UFR1230 disconnecting from USM3
Actuators have internal limit switches that spot travel at the end positions.
Also note that there is more movement than the actuator has eg 55mm movement for the 50mm actuator so it’s not jamming up.
Also note that there is more movement than the actuator has eg 55mm movement for the 50mm actuator so it’s not jamming up.