No sound

[Docomar750]

Hi

All wired in but can’t get any sound outputs work ok have ordered a pot as can’t get transmitter to adjust volume that way. Yes I do have experience with your systems as I have USM RC 2s & 3s?

[BEIER-Electronic Andy]

What do the LEDs on the MSM-1 do when you turn on the power?

[Docomar750]

Hi

Green on blue flash a couple of times then solid green when I hold three way switch in position as instructed blue light comes on then nothing happens and light goes off just wondering if I would be better with using a stick input?

[Rascal]

Green on blue flash a couple of times then solid green when I hold three way switch in position as instructed blue light comes on then nothing happens and light goes off just wondering if I would be better with using a stick input?

What comes between "I hold three way switch in position" and "then nothing happens", i.e. did you release the switch after 2 seconds when the blue light came on and then move the switch to A or D to raise or lower the volume respectively?
Or did you just keep on holding the switch?

[Docomar750]

Tried both ways nothing hopefully the volume pot arrives soon then I can test properly as it’s the beier 100k pot

[BEIER-Electronic Andy]

Unfortunately, the volume control pot won't help, as it only makes the volume quieter, not louder (than without the pot).

What model number did you set on the MSM-1? If you've already changed the model number, please set it back to no. 1 and test if the sound works.

Do you have the K-USB-2 data cable?

[Docomar750]

Hi

Yes set back to model 1 no sound was on ship 2 and yes usb data cable.

[Docomar750]

Can the data cable be used and what software would be needed?

[BEIER-Electronic Andy]

There's also a Sound Teacher for the MSM-1. Not official yet...

You can't edit projects with the Sound Teacher. However, you can:
- Run and record a diagnosis using the data cable
- Update firmware
- Re-transfer the sound image of the 14 models

You can download the Sound Teacher here:
https://www.beier-electronic.de/modellb ... V1.00a.exe

Then, please run a diagnosis and start a record. Try enabling a sound while recording.

[Docomar750]

ok

sound teacher running diagnostics can see sound activating during testing (ie sound Nr i can see values changing) no sound tried everything it says in the manual tried 3 speakers still no actual sound. Now also when switching on i get green LED blue flashing 5 times but the red randomly coming on for 6 seconds. I take it there should be voltage on the sound pins when a signal is produced but on test all i get is continuity (short?)