Rear lights

[Remi]

roll: Good morning! I picked up the sound module hoping that it could offer the necessary quality functions on the truck without wasting time on programming. I can accept the automatic shutdown after thirty seconds, I can accept the turning on of the four indicators when reversing, but I don't understand why, despite following the instructions in the small manual, the rear lights don't always stay on. It is unthinkable to believe that it does not have this function by default. Advice or directions welcome

[Rascal]

Hello Remi,

can you please let us know which model # you have selected and which function/output you are referring to as "rear lights"?

E.g. Prop #X A - short (or other) and/or output X.

[Remi]

Truck 3

[Remi]

Connection MSM-1

[Rascal]

It seems you have connected the light to output 7, which is the brake light. According to the manual the break light will be switched off when the engine sound is switched off.

From the manual page 11:

When braking, the brake light is activated. In addition, the brake light is always on when stationary as long as the driving sound is on.

Use output 1 to 4 for other lights, they can be controlled via Prop #6. If you need to combine rear light and brake light into one LED for each side wire the two outputs as shown in the PDF of the first post here.