PROBLEM WITH MY SFR-1

[john glazbrook]

Hi all
i need help with my sfr-1, when i press the blue button to configure it to my transmitter it doesnt seem to work, i long press the blue button waite untill the blue light comes on, push throttle to high blue light flashes, push throttle to full low, blue light flashes 3 times, but the blue light stays on.

can somebody please help to rectifie the problem

[Rascal]

Hello,

first make sure you execute the following steps:

1. Connect throttle channel, steering channel and all other proportional channels you want to use to your receiver.
2. All channels must be in neutral position. Switch on transmitter first and then the SFR-1.
3. Activate the setup, with the blue „Setup“ button on the SFR-1 board, until the green LED flashes fast. The blue LED flashes once.

Please confirm if step 3. is successful, observing the correct LEDs.

[john glazbrook]

Thank you rascal, I have done all of your suggestion, but the blue light continues to flash

[Rascal]

So what does the green and red LED do?

[john glazbrook]

The green and blue flash together, the red light stays off

[Rascal]

Does the blue LED flash slow or fast?

If slow - check battery voltage.

If fast - are you using SBUS, SUMD or iBUS?

[john glazbrook]

Sorry rascal, I gave you the wrong information, the green light stays on, the blue light flashes fast..qpologies

[Rascal]

Does the SD card have a project on it? If not please save a project to it first, you can find examples on the DVD or USB stick.

If you already have a project created please upload the file (*.sfr) here.

[john glazbrook]

Yes rascal it does have a project on it, thank you

[Rascal]

Please upload the file here.

When you reply to this post click on "Dateianhänge", then "Datei hinzufügen" and then select the file (*.sfr) to be uploaded.