SBUS with UFR and USM

Fahrtregler für RC-Trucks und andere Fahrzeuge
Antworten
skinkemaster
Beiträge: 2
Registriert: So 24. Mär 2019, 19:10

SBUS with UFR and USM

Beitrag von skinkemaster »

Hi

I need help putting UFR and USM together with SBUS.

All lighting functions must run on the USM module.

Should they be connected to a Y servo cable or how?
Benutzeravatar
BEIER-Electronic Andy
Administrator
Beiträge: 4140
Registriert: Mi 17. Dez 2008, 07:37

Re: SBUS with UFR and USM

Beitrag von BEIER-Electronic Andy »

If you want to use S-Bus on both modules, then you need an Y-servo cable for the S-Bus signal.

But remember, if you activate S-Bus at the USM-RC-2, then you can't use the "digital communication" between UFR and USM.
skinkemaster
Beiträge: 2
Registriert: So 24. Mär 2019, 19:10

Re: SBUS with UFR and USM

Beitrag von skinkemaster »

But how do I make the sound fit/follow the engine rpm?

Because in, this way it goes idle as soon as you release the gas. But the car drives with cruise control.
Rascal
Beiträge: 3252
Registriert: Do 9. Okt 2014, 01:31

Re: SBUS with UFR and USM

Beitrag von Rascal »

You disable the "digital communication" in the UFR and USM as Andy said and instead activate the "Digital Mode" in the USM. Then connect UFR X4/1 with USM X2/1; this way the USM behaves as any other soundmodule that would be connected to the UFR as far as the speed signal is concerned.

See also the UFR manual page 9 and 12 (English version).
Antworten