Der SFR-1 fährt nur in eine Richtung

Häufig gestellte Fragen - und die passenden Antworten
Antworten
Benutzeravatar
BEIER-Electronic Andy
Administrator
Beiträge: 4150
Registriert: Mi 17. Dez 2008, 07:37

Der SFR-1 fährt nur in eine Richtung

Beitrag von BEIER-Electronic Andy »

Frage:
Der SFR-1 fährt nur noch vorwärts (bzw. nur noch rückwärts)


Antwort:
Meist ist hierfür die aktivierte Option "Fahrtregler mit Bremsfunktion" verantwortlich.

SFR-1_Bremsfunktion_1.png
SFR-1_Bremsfunktion_1.png (9.2 KiB) 6455 mal betrachtet

Ist diese Option aktiviert, hat der Gasknüppel eine andere Funktion als normal:
Gas nach vorne: Gas geben (entspricht dem Gaspedal bei einem realen Fahrzeug)
Gas nach hinten: Bremsen (entspricht dem Bremspedal bei einem realen Fahrzeug)

Daher muss hier zum Ändern der Fahrtrichtung die Funktion "Fahrtrichtungswechsel" über den Sender aktiviert werden (entspricht dem Einlegen des Rückwärtsgangs bei einem realen Fahrzeug). Siehe auch Anleitung Seite 60.

SFR-1_Bremsfunktion_2.png
SFR-1_Bremsfunktion_2.png (12.63 KiB) 6455 mal betrachtet

Besteht das Problem trotzdem, obwohl die Option "Fahrtregler mit Bremsfunktion" nicht aktiviert ist, dann kann auch das Gaskanal-Setup dafür verantwortlich sein. Siehe Anleitung Seite 17. Wird das Setup nicht korrekt durchgeführt, kann aus dem SFR-1 auch ein reiner Vorwärts-Fahrtregler gemacht werden.
Benutzeravatar
BEIER-Electronic Andy
Administrator
Beiträge: 4150
Registriert: Mi 17. Dez 2008, 07:37

Re: Der SFR-1 fährt nur in eine Richtung

Beitrag von BEIER-Electronic Andy »

Question:
The SFR-1 only moves forwards (or only backwards)


Antwort:
The activated “Speed controller with braking function” option is usually responsible for this.

SFR-1_Bremsfunktion_3.png
SFR-1_Bremsfunktion_3.png (7.52 KiB) 52 mal betrachtet

If this option is activated, the throttle stick has a different function than normal:
Stick forward: Accelerate (equivalent to the throttle pedal on a real vehicle)
Stick to the rear: Braking (equivalent to the brake pedal on a real vehicle)

Therefore, to change the direction, the "Change of direction" function must be activated via the radio (corresponds to engaging reverse gear on a real vehicle). See also Manual page 61.

SFR-1_Bremsfunktion_4.png
SFR-1_Bremsfunktion_4.png (10.37 KiB) 52 mal betrachtet

If the problem still exists even though the "Speed controller with braking function" option is not activated, then the throttle channel setup may also be responsible. See Manual page 16. If the setup is not done correctly, the SFR- 1 can also be turned into a pure forward speed controller.
Antworten