Hi everybody,
It's me a gain with new issue. I'm configuring now the MG1 & 2. I have issue with LED light2 of MG1 + 2 are flashing at the same time.
This is the configuration. I actually don't understand the number in Option 1 for Output 1 (5) & Output 2 (10)
Machine Gun 1 & Machine Gun 2 configu
Machine Gun 1 & Machine Gun 2 configu
Zuletzt geändert von thuat.bui am Sa 30. Jul 2022, 11:50, insgesamt 1-mal geändert.
Re: Machine Gun 1 & Machine Gun 2 configu
This is the last screenshot and configuration .sfr-1-d file
Re: Machine Gun 1 & Machine Gun 2 configu
Hello again,
You do not need to select any output there if you activate the sound and output via multi-function or function-sequence!
Only if you activate the sound function and you want to switch on an output simultaneously (without using multi-function or function-sequence), i.e. while that particular sound is being played, the box of the corresponding output/s should be checked; see also below.
So remove all the "ticks" and it should work.
Here is a free tip :
Use output type "Flickering (sound)" to synchronize the output with the sound, Option 1 defines the sensitivity. In this case you must check the corresponding output under Additional sound. Then use function "Additional sound x" only, i.e. do not call the function for the output itself.
You can trigger "Additional sound x" by its own, in a function-sequence and also multi-function, whichever you prefer.
you can see the meaning of the options when you hover the mouse over those fields: the value defines the frequency or duration of the flashing or pulse respectively with the given multiplier applied. See also page 37 of the manual (English version).I actually don't understand the number in Option 1 for Output 1 (5) & Output 2 (10)
The screenshots do not match the configuration file you attached but I think the problem is with the Additional sound configuration as you have checked the output boxes there, e.g. "Additional sound 1 (start/loop)" as well as "Additional sound 3" trigger output 1 and 2 everytime when additional sound 1 or 3 is played.I have issue with LED light2 of MG1 + 2 are flashing at the same time.
You do not need to select any output there if you activate the sound and output via multi-function or function-sequence!
Only if you activate the sound function and you want to switch on an output simultaneously (without using multi-function or function-sequence), i.e. while that particular sound is being played, the box of the corresponding output/s should be checked; see also below.
So remove all the "ticks" and it should work.
Here is a free tip :
Use output type "Flickering (sound)" to synchronize the output with the sound, Option 1 defines the sensitivity. In this case you must check the corresponding output under Additional sound. Then use function "Additional sound x" only, i.e. do not call the function for the output itself.
You can trigger "Additional sound x" by its own, in a function-sequence and also multi-function, whichever you prefer.
Re: Machine Gun 1 & Machine Gun 2 configu
It's work for me now with your instruction. Thanks a lot! Very quick and helpful support.