Hi
I need help putting UFR and USM together with SBUS.
All lighting functions must run on the USM module.
Should they be connected to a Y servo cable or how?
SBUS with UFR and USM
- BEIER-Electronic Andy
- Administrator
- Beiträge: 3973
- Registriert: Mi 17. Dez 2008, 07:37
Re: SBUS with UFR and USM
If you want to use S-Bus on both modules, then you need an Y-servo cable for the S-Bus signal.
But remember, if you activate S-Bus at the USM-RC-2, then you can't use the "digital communication" between UFR and USM.
But remember, if you activate S-Bus at the USM-RC-2, then you can't use the "digital communication" between UFR and USM.
-
- Beiträge: 2
- Registriert: So 24. Mär 2019, 19:10
Re: SBUS with UFR and USM
But how do I make the sound fit/follow the engine rpm?
Because in, this way it goes idle as soon as you release the gas. But the car drives with cruise control.
Because in, this way it goes idle as soon as you release the gas. But the car drives with cruise control.
Re: SBUS with UFR and USM
You disable the "digital communication" in the UFR and USM as Andy said and instead activate the "Digital Mode" in the USM. Then connect UFR X4/1 with USM X2/1; this way the USM behaves as any other soundmodule that would be connected to the UFR as far as the speed signal is concerned.
See also the UFR manual page 9 and 12 (English version).
See also the UFR manual page 9 and 12 (English version).