I have a SM-IR-16-2 with a speedregulator on IR-servo-1.
In Sound Teacher I have set it to Direct servocontrol via channel 2.
It works fine as long as I switch on in this sequence:
Transmitter
USM-RC-2
SM-IR-16-2
but if I switch off the transmitter or select another model, the engine on the speedregulator on SM-IR-16-2 are starting to run.
Sometimes it also happens if I switch on the SM-IR-16-2 without any IR connection.
If I park the trailer, so the IR connection are disabled, it stands still.
Servo-output has its own life
Servo-output has its own life
Feel free to answer in german, I can read it but not write it.
Leonard - DK
Leonard - DK
- BEIER-Electronic Andy
- Administrator
- Beiträge: 4140
- Registriert: Mi 17. Dez 2008, 07:37
Re: Servo-output has its own life
Hallo Leonard,
wenn das USM-RC-2 vom Empfänger keine Impulse bekommt, werden die Servoausgänge am SM-IR-16-2 bei der direkten Servoansteuerung momentan auf den Miminal-Anschlag (1,0ms) gefahren, was beim Fahrtregler ja leider Vollgas entspricht
Dieser Fehler wird beim nächsten Update behoben. Das Update wird wahrscheinlich so in ca. 2-3 Wochen als Beta-Version zur Verfügung stehen.
wenn das USM-RC-2 vom Empfänger keine Impulse bekommt, werden die Servoausgänge am SM-IR-16-2 bei der direkten Servoansteuerung momentan auf den Miminal-Anschlag (1,0ms) gefahren, was beim Fahrtregler ja leider Vollgas entspricht
Dieser Fehler wird beim nächsten Update behoben. Das Update wird wahrscheinlich so in ca. 2-3 Wochen als Beta-Version zur Verfügung stehen.
Re: Servo-output has its own life
I have changed from using Futaba Fasst to FrSKY Taranis Plus with the X8R receiver and it did the trick.
Now I can change model or switch off my transmitter and the IR Servo will not react.
Now I can change model or switch off my transmitter and the IR Servo will not react.
Feel free to answer in german, I can read it but not write it.
Leonard - DK
Leonard - DK