Die Suche ergab 6 Treffer
- Di 19. Nov 2024, 23:08
- Forum: Nautic-/Multiswitchmodule
- Thema: EMS-16-G in a FlySky FS-i6X
- Antworten: 2
- Zugriffe: 9725
Re: EMS-16-G in a FlySky FS-i6X
Ah, I wanted to do the direct proportional control of the landing gear because all the trailers have different mechanisms and thus different travel speeds. I'm especially concerned with the Detachable Gooseneck lowboy because I'm simulating a hydraulic neck with a worm gear and gear segment, and onc...
- Di 19. Nov 2024, 20:21
- Forum: Nautic-/Multiswitchmodule
- Thema: EMS-16-G in a FlySky FS-i6X
- Antworten: 2
- Zugriffe: 9725
EMS-16-G in a FlySky FS-i6X
So I've been silent a while. My truck project went on hold when dad died and mom got cancer. Mom is doing much better now and I've had a chance to dig back into these side projects again. I've acquired a Flysky FS-i6X, and in converting the left stick to self-centering, I noticed all the shoulder sw...
- Di 31. Jan 2023, 19:26
- Forum: Soundmodul USM-RC-3
- Thema: Noob question on engine sounds
- Antworten: 4
- Zugriffe: 5624
Re: Noob question on engine sounds
It was Fast Switching. Fast Switching was turned off, because a Youtube tutorial said 'It causes problems so leave it off.'
Turned it on and now everything works as intended.
I apologize for the confusion, thank you for your time and concern.
Turned it on and now everything works as intended.
I apologize for the confusion, thank you for your time and concern.
- Di 31. Jan 2023, 18:59
- Forum: Soundmodul USM-RC-3
- Thema: Noob question on engine sounds
- Antworten: 4
- Zugriffe: 5624
Re: Noob question on engine sounds
Actually, now that I've been trying to get this to work a bit more, I noticed that the system isn't playing any of the additional engine sounds. It plays the Cold Crank sound to start the engine, and then it plays the Idle sound. When I pull the throttle trigger, it doesn't play either Vehicle Start...
- Di 31. Jan 2023, 14:59
- Forum: Soundmodul USM-RC-3
- Thema: Noob question on engine sounds
- Antworten: 4
- Zugriffe: 5624
Re: Noob question on engine sounds
Here are the files. Sorry this is so late, but... Time zones, I'm in Atlantic Canada. In the diagnostic recording, the engine brake rumble cut in somewhere around the 30 second mark, but it also was the only engine sound at idle and during acceleration up until around 48 seconds. Thank you for your ...
- Di 31. Jan 2023, 06:12
- Forum: Soundmodul USM-RC-3
- Thema: Noob question on engine sounds
- Antworten: 4
- Zugriffe: 5624
Noob question on engine sounds
So I've finally sat down and done my first steps into building my Globe Liner, which is to wire up the electronics first before even building to see if they'll even work. I have the USM RC 3 hooked up with six patch cables for 1 to 6, with 1 and 2 swapped, because I'm using a Flysky GT5 pistol grip ...